Table of Contents
Advertisement
Procedures
............................................................................................................................................................................................................................................................
Parameter
Out Label
PHB Profile
Primary State
L2 Encapsulation Profile
........................................................................................................................................................................................................................
3
Click Select to select the MPLS Port as shown in
Figure 5-86 Port - select
........................................................................................................................................................................................................................
4
Select the radio button to choose the MPLS Port Access Identifier and click Apply &
Exit.
........................................................................................................................................................................................................................
5
Click Cancel to return to the previous panel.
........................................................................................................................................................................................................................
6
Click Select to choose the PHB Profile as shown in
............................................................................................................................................................................................................................................................
5 - 11 2
Description
Specifies transmitted Label for outgoing segment associated
to Source Pseudowire Segment. The parameter is not
relevant if DIR=UNIDIRIN. The label value must be unique
in the system. The valid range is 1024-1048575
Specifies the AID of PHB Profile resource
Specifies the primary state, IS/OOS. The default is IS
Specifies the L2 Encapsulation Profile AID to be used in
case of mapping of MPLS over Ethernet when a switched
network is present. The parameter is relevant only if PORT
parameter refers to Local MPLS interface
Figure
Figure
Create transit pseudowire
5-86.
5-87.
Issue 1 February 2009
8DG08763KAAA
Advertisement
Chapters
Table of Contents
