Alcatel-Lucent 1850 User Provisioning Manual page 204

Tree area
............................................................................................................................................................................................................................................................
Figure 4-5 AM tree
The Link Aggregation Management tab displays the existing LAGs and a Link
Aggregation Creation panel that contains the following parameters:
Name - Allows to set the name of the LAG. The only suffix after "#" can be set by the
•
user, with an integer in the range 1-123.
Admin State - Administration status. The entry field can be set only after the LAG
•
creation option, see
in-service) or disable (the LAG is out-of-service).
Type - Indicates the type of port (read only field, fixed by the system to
•
"ieee8023adLag").
LACP Type - Indicates if the Link Aggregation Control Protocol is ON (i.e. lacpOn is
•
active on this aggregator) or OFF (IacpOff inactive); read only field, fixed by the
system.
User Label - Indicates the LAG name as defined by the user.
•
Size - Allows to set the size of the LAG, i.e. number of Aggregated Ports. The values
•
are integers in the range 0 -16.
Actor Admin Key - Indicates the LAG "Key", the parameter identifying this LAG;
•
integer in the range 1 -123.
EthClient Type - The entry field can be set only after creation, see
•
Management panel" (p.
System) or etb (for Ethernet Bridge System).
............................................................................................................................................................................................................................................................
4 - 6
"LAG configuration" (p.
4-11). Possible values are: ets (for Ethernet Transparent
4-8). The values are: enable (the LAG is
Overview
"Client Type
8DG08763KAAA
Issue 1 February 2009