Alcatel-Lucent 1850 User Provisioning Manual page 247

Tree area
............................................................................................................................................................................................................................................................
– Jack Type List - Specifies the available connectors type. The values are: RJ45 for
– Jabber state - Specifies the state of the jabber process (checking about abnormal
– Default Type - Specifies the type of physical I/F. The values are:
– RemoteClientFail cons. actions - Allows to chose one of the following options:
If shutdown is selected, then the Tx i/f (towards the Ethernet line) of this Local Port will
be set in shutDown state, in case of InternalLoopBack on this port, or in case of CSF
alarm detection on the remote port connected to this port.
– CSF MAU Action
– SSF MAU Action
– Auto-negotiation supported - Indicates if the auto-negotiation is supported or
– Auto-negotiation enabled - Indicates if the auto-negotiation is enabled or not.
The panel has the following hyperlinks:
Save link - To save the settings.
Enable autonegotiation - To change the last described field without using other page
command.
Flow management panel - Allows to change the settings of the resource and displays
•
the following parameters:
– VLAN protocol profile - Allows to chose one of the existing VLAN Profile or
Aggregation Port panel - Allows to configure the Link Aggregation (LAG). Click
•
Configure LAG link to configure a new LAG.
Egress Shaping Management panel - Displays the following parameter:
•
– Egress Shaping rate (Kbps)
(T)MPLS Management panel - Click CREATE MPLSIF link to create new
•
MPLSIF.
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
FE port or fiberLC for GbE port.
data transmissions longer than the max permissible packet length).
• 10BaseTFD for E-10Mbps LAN (FD= FullDuplex)
• 100BaseTXFD for FE-100Mbps LAN
• 1000BaseXFD for 1GE (1000Mbps) LAN
• b10GBaseR for 10GE (10000Mbps) LAN
• disabled
• Transmitter shutdown
• symmetric - To enable the Flow Control function, in symmetric mode (i.e. it
can transmit and receive Pause Frames).
not. The values are: true or false.
The values are: enabled or disabled.
setting don't care.
Access a module
4 - 4 9