Alcatel-Lucent 1850 User Provisioning Manual page 530

Appendix
............................................................................................................................................................................................................................................................
Command
ED-NETIF
ED-NTP
............................................................................................................................................................................................................................................................
6 - 13 6
Description
DCC Channel, specifies whether
the referred DCC is a Line DCC
or a Section DCC.
Internet Protocol. Determines if
the Internet Protocol will be run
on the addressed DCC or not.
Integrated ISIS. Determines if the
Integrated IS-IS Protocol will be
run on the addresssed DCC or not.
Layer 2 User side or Network side
roles, it specifies whether the layer
2 user side or layer 2 network side
role shall be assigned to the NE
when using LAPD for layer 2.
Note that this value shall be the
opposite of what has been set on
the far end NE.
Lower Layer Mode, it specifies
the protocol used for the Layer 2
over the specified DCC.
OSI. Determines if the OSI
Protocol will be run on the
addressed DCC or not.
OSI Area. Determines as to which
OSI Area the Customer LAN
belongs to.
Enable or disable time
synchronization from the NTP
server. Factory Default is
DISABLE
Time offset to apply to NTP server
UTC time, +/- HH-MM, for all
events and time stamps reported
by this NE. Factory default is +00-
00.
Parameter defaults
Parameter Default
DCCCHNL Entry Required
IP <Previously
existing value>
INTISIS <Previously
existing value>
L2SIDE <Previously
existing value>
LLMODE <Previously
existing value>
OSI <Previously
existing value>
OSIAREA <1, if OSI was
disabled
previously,
previously existing
value, otherwise>
NTP <currently
provisioned value>
OFFSET <currently
provisioned value>
Issue 1 February 2009
8DG08763KAAA