Table of Contents
Advertisement
Procedures
............................................................................................................................................................................................................................................................
Parameter
PIR - Peak Information Rate [kb/sec]
CBS - Committed Burst Size [bytes]
PBS - Peak Burst Size [bytes]
Rate
Service type
........................................................................................................................................................................................................................
12
Click Cancel to delete the selected Traffic Descriptor
........................................................................................................................................................................................................................
13
Click Save & Exit to create a new Traffic Descriptor in the following described and leave
the page
........................................................................................................................................................................................................................
14
Click Save & Continue to create a new Traffic Descriptor in the following described and
create another one.
When this dialog is recalled by a resource configuration, it displays the
additional keys "Apply" (to associate the selected Traffic Descriptor to the
resource), and "Cancel" (to exit without TD association).
E
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
O
S
F
T E P S
Create traffic descriptor (data)
Description
This is the maximum rate (expressed in kb/sec)
up to which the source can transmit for a short
time period and it ranges from 3 to physical-line-
rate of the relative Port
This is the committed number of bytes for which
the source may transmit the PIR; it ranges from 0
to 64 MBytes. It can be set only if the
regulatedService traffic has been selected; in
besEffortService case it is set to 0 by the system;
in guaranteedService case it is set equal to PBS
value. A value greater than MTU (e.g. 2000) is
advisable
This is the maximum number of bytes for which
the source may transmit the PIR; it ranges from 1
to 64 MBytes (this max value cannot be greater
than the minimum value of 64 MB or 256xCBS.
I.e.: if CBS=2000, then PBS< 512 kB). A value
greater than MTU (e.g. 2000) is advisable
Specifies the bit rate for the multicast and
unknown traffic
Specifies the type of service for the multicast and
unknown traffic
5 - 2 7
Advertisement
Chapters
Table of Contents
