Alcatel-Lucent 1850 User Provisioning Manual page 538

Appendix
............................................................................................................................................................................................................................................................
Command
ED-VCG
............................................................................................................................................................................................................................................................
6 - 14 4
Description
Maximum Number of Members.
If the MAXMBR (say N*) given
in this command is greater than
the maximum number of members
in the VCG at the time of issuance
of this command (say N), then
N*-N members of the same type
as the other members of the VCG
are added to the VCG. If the
MAXMBR (say N*) given in this
command is less than the
maximum number of members in
the VCG at the time of issuance of
this command (say N), then N-N*
members of the same type as the
other members of the VCG are
deleted from the VCG. In both
cases N* becomes the new
maximum number of members for
the addressed VCG.
Hold Off Time. It specifies the
time, in milliseconds, to wait
before considering a member of
the addressed virtual
concatenation group in failure
condition after a defect has
occurred on that member. Valid
only if LCAS is Enabled. A
HLDOFFTIME of 0 means there
is no hold off time.
LCAS Control. Indicates if the
LCAS is enabled or disabled for
the VCG.
Re-sequence Acknowledge
timeout. This indicates the time, in
milliseconds,the LCAS protocol
waits for the re-sequence
acknowledge message. Valid only
if the LCAS is Enabled.
Signal Degrade Mode. Indicates if
the signal degrade on the
constituent member of the VCG
contributes to its fail condition.
Valid only when LCAS is
Enabled.
Wait to Restore Time. It specifies
time to wait (in milliseconds)
before considering a member of
the VCG in failure condition.
Valid only if LCAS is Enabled.
WTRTIME of 0 indicates that
there is no wait to restore time.
Parameter defaults
Parameter Default
MAXMBR <Previously
existing value>
HLDOFFTI <Previously
ME existing value>
LCASENAB <Previously
LE existing value>
RSQACKTO <Previously
UT existing value>
factory default 512
SDMODE <Previously
existing value>
factory default N
WTRTIME <Previously
existing value>
8DG08763KAAA
factory default 500
Issue 1 February 2009