System Management - In-Service Upgrade - Start - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
Stop Completed (STPC) - Indicates that the STP-ISU command completed
•
successfully
In-service upgrade and start upgrade
The system performs a series of consistency checks on the actual configuration to make
sure that the system is in a state that can successfully be upgraded to the new release.
During command execution, the system remains in-service and continues to provide
protection switching and alarm reporting functionality on the current release. To assure
that the consistency checks are done on a consistent NE database, TL1 commands that
would alter the NE configuration are rejected during the ongoing consistency checks.
The performed consistency checks shall assure that the upgrade from the current (old)
release to the specified new release can be done successfully. The performed checks
include:
Verification that a new release software has been downloaded to the NE.
•
Verification that the downloaded software matches the specified new release build
•
identifier.
Verification of the NE configuration of the current release is fully supported by the
•
new release (anticipating any known incompatibilities between old and new release).
Select System Management -> Initialize and Upgrade -> In-Service Upgrade -> Start
Upgrade as shown in
Figure 3-81 System Management - In-Service Upgrade - Start
The In-Service Upgrade tab displays the Start In-Service Upgrade panel that shows the
status of the in-service upgrade. The status are the same described in
and start
The panel has the Apply hyperlink that is used to start the in-service upgrade process.
In-service upgrade and stop upgrade
This option halts/stops the in-service upgrade procedure and reverts the system to the state
before the Start Upgrade command was issued. The downloaded new release software is
removed from the NE.
Select System Management -> Initialize and Upgrade -> In-Service Upgrade -> Stop
Upgrade as shown in
............................................................................................................................................................................................................................................................
3 - 84
Figure 3-81.
upgrade, it presents the Start In-Service Upgrade? field.
Figure 3-82.
System management menu
In-service upgrade
8DG08763KAAA
Issue 1 February 2009