Alcatel-Lucent 1850 User Provisioning Manual page 246

Tree area
............................................................................................................................................................................................................................................................
Promiscuous mode - Indicates indicating whether this interface has to inspect the
•
packets' MAC addresses. The values are: true or false.
FCS discard errored frame - Indicates the insertion or removal of GFP-FCS (Frame
•
Check Sequence) field into the optional field FCS of the GFP frame. The values are:
true or false.
Client type - Indicates the transported layer. The values are: ets (for Ethernet
•
Transparent System), etb (for Ethernet Bridge System) or LinkAgg (for Link
Aggregation System).
Default PAUSE behavior: The combo-box allows to chose the pause signal that is
•
inserted for Flow Control signalling. It applies only in the case that the
"AutoNegotiation-AdminStatus" is in "disabled". The choices are:
– disabled - To disable the Flow Control function
– asymmetric - To enable the Flow Control function, in asymmetric mode (i.e. it can
– symmetric - To enable the Flow Control function, in symmetric mode (i.e. it can
Adm. fractional rate - Indicates the possible Fractional Rates, at the relevant payload
•
capacity:
– if STS-3c SPE/VC4, the possibilities are: "Fractional 100,000,000 kb/s SDH Rate"
– if STS-1 SPE (not yet available), the possibilities are: "Fractional 10,000,000 kb/s
– if VT 2 SPE (not yet available)
Underlie layer - Indicates the associated layer. The allowable values are: mau (for
•
Ethernet Transparent System), vconc (virtual concatenation to permit the setting of the
"virtual-concatenation granularity" mode) or sdh (to permit the setting of the "Rate-
Limiting" mode. NOTE: this value is given only in the case that the concatenation
number for the VC4 is equal to 1).
Link up/down trap - Indicates whether linkUp / linkDown traps (notification upon
•
the changing of the node operational state from up to down and vice versa) should be
generated for this interface. possible options: enabled / disabled the associated layer.
The values are: enabled or disabled.
The panel has the Save hyperlink in order to save the settings.
MAU panel - Allows to change the settings of the resource and displays the following
•
parameters:
– MAU identifier - Specifies a number assigned by the system. The value is: 1.
– Front Panel Port - Specifies a number assigned by the system; it is the identifier
– State - Specifies the MAU current status. The values are: operational or
............................................................................................................................................................................................................................................................
4 - 48
transmit Pause Frames, but ignores incoming Pause Frames)
transmit and receive Pause Frames)
or "No Rate Limit"
SDH Rate" or "No Rate Limit"
of the physical port on the front of the PIM. The value is: <8 digit number>.
shutdown.
Access a module
8DG08763KAAA
Issue 1 February 2009