Tceventlogger And Io - Beckhoff EPP3504-0023 Short Manual

Appendix
Text ID Type Place
0x840A Error Drive
0x8415 Error Drive
0x8416 Error Drive
0x8417 Error Drive
0x841C Error Drive
0x8550 Error Inputs
0x8551 Error Inputs
0x8552 Error Inputs
0x8553 Error Inputs
0x8581 Error Inputs
0x8600 Error General IO
0x8601 Error General IO
0x8602 Error General IO
0x8603 Error General IO
0x8610 Error General IO
0x8611 Error General IO
0x8612 Error General IO
0x8613 Error General IO
0x8700 Error
0x8701 Error
0x8702 Error
0x8703 Error
0x8704 Error
0x8705 Error
0x8706 Error
0x8707 Error
0x8708 Error
0x8709 Error
0x870A Error
0x870B Error
0xFFFF Information
8.2

TcEventLogger and IO

The TwinCAT 3 EventLogger provides an interface for the exchange of messages between TwinCAT
components and non-TwinCAT components.
226
Text Message
Overall current threshold
exceeded
Invalid modulo factor: %d
Motor overtemperature
Maximum rotating field velocity
exceeded
STO while the axis was enabled
Zero crossing phase %X missing Zero crossing phase %X missing
Phase sequence Error
Overcurrent phase %X
Overcurrent neutral wire
Wire broken Ch %D
Wrong supply voltage range
Supply voltage to low
Supply voltage to high
Over current of supply voltage
Wrong output voltage range
Output voltage to low
Output voltage to high
Over current of output voltage
Channel/Interface not calibrated
Operating time was manipulated
Oversampling setting is not
possible
No slave controller found
Slave controller is not in
Bootstrap
Processor usage to high (>=
100%%)
Channel in saturation
Channel overload
Overloadtime was manipulated
Saturationtime was manipulated
Channel range error
no ADC clock
Debug: 0x%X, 0x%X, 0x%X
Version: 1.2
Additional comment
• The I2T-model of the motor is incorrectly
parameterized.
Total current exceeded
Modulo factor invalid
The internal temperature of the motor exceeds the
parameterized error threshold. The motor stops
immediately. Activation of the output stage is
prevented.
Rotary field speed exceeds the value specified for dual
use (EU 1382/2014).
An attempt was made to activate the axis, despite the
fact that no voltage is present at the STO input.
Wrong direction of rotation
Overcurrent phase %X
Overcurrent neutral wire
Wire broken Ch %d
Supply voltage not in the correct range
Supply voltage too low
Supply voltage too high
Overcurrent of supply voltage
Output voltage not in the correct range
Output voltage too low
Output voltage too high
Overcurrent of output voltage
Channel/interface not synchronized
Operating time was manipulated
Oversampling setting not possible
No slave controller found
Slave controller is not in bootstrap
Processor load too high (>= 100%%)
Channel in saturation
Channel overload
Overload time was manipulated
Saturation time was manipulated
Measuring range error for the channel
No ADC clock available
Debug: 0x%X, 0x%X, 0x%X
EPP3504-0023