Beckhoff EPP3504-0023 Short Manual page 130

Commissioning on EtherCAT Master
Fig. 54: Selection of the target system
Use "Search (Ethernet)..." to enter the target system. Thus another dialog opens to either:
• enter the known computer name after "Enter Host Name / IP:" (as shown in red)
• perform a "Broadcast Search" (if the exact computer name is not known)
• enter the known computer – IP or AmsNetID
Fig. 55: specify the PLC for access by the TwinCAT System Manager: selection of the target system
Once the target system has been entered, it is available for selection as follows (a correct password may
have to be entered before this):
After confirmation with "OK", the target system can be accessed via the System Manager.
130 Version: 1.2 EPP3504-0023