Regc; Usbm; Usbp; Usbpuc - NEC mPD78F0730 Preliminary User's Manual

2.2.7 REGC

This is the pin for connecting regulator output (2.5 V) stabilization capacitance for internal operation. Connect this
pin to V via a capacitor (0.47 to 1.0
SS
Caution Keep the wiring length as short as possible for the broken-line part in the above figure.

2.2.8 USBM

This is the pin for inputting/outputting data (−) to USB ports.

2.2.9 USBP

This is the pin for inputting/outputting data (+) to USB ports.

2.2.10 USBPUC

This is the pin for controlling pull-up resistors connected to USB ports.

2.2.11 USBREGC

This is the pin for connecting regulator output (3.3 V) stabilization capacitance for USB ports. Connect this pin to
V via a capacitor (0.47 to 1.0
SS
2.2.12 V and EV
DD
V is the positive power supply pin for P121, P122 and other than ports.
DD
EV is the positive power supply pin for ports other than P121 and P122.
DD
2.2.13 V and EV
SS
V is the ground potential pin for P121, P122 and other than ports.
SS
EV is the ground potential pin for ports other than P121 and P122.
SS

2.2.14 FLMD0

This is a pin for setting flash memory programming mode.
Connect FLMD0 to EV
In flash memory programming mode, connect this pin to the flash programmer.
26
Downloaded from Elcodis.com electronic components distributor
CHAPTER 2 PIN FUNCTIONS
µ
F: recommended).
µ
F: recommended).
DD
SS
or V in the normal operation mode.
SS SS
Preliminary User's Manual U19014EJ1V0UD
REGC
V
SS