Edsff Cage Replacement; Remove An Edsff Cage - Lenovo ThinkSystem SR635 V3 User Manual

Step 1. Install any parts you removed and connect the cables.
Step 2. Touch the static-protective package that contains the CMOS battery to any unpainted surface on
the outside of the server. Then, take the CMOS battery out of the package.
Step 3. Install the CMOS battery. Ensure that the CMOS battery is seated in place.
Note: Before you install the CMOS battery from or into the socket, differentiate between the
positive and negative ends. Use the illustration above for guidance.
Note: Before you install the battery into the socket, make sure that the positive side faces upward.
1. Tilt the battery and insert it to the positive end on the socket, and make sure that the
battery goes tight to the metal clip.
2. Press the battery down until it clicks into the socket.
Figure 33. CMOS battery installation
After you finish
1. Complete the parts replacement. See
2. Use the Setup utility to set the date, time, and any passwords.

EDSFF cage replacement

Use this information to remove and install an EDSFF cage.

Remove an EDSFF cage

Use this information to remove an EDSFF cage.
"Complete the parts replacement" on page 215.
.
Chapter 5 Hardware replacement procedures
75