Table of Contents
Advertisement
a.
Place the tip of the tool in the recess on the top of the retaining clip.
b.
Carefully rotate the retaining clip away from the memory module slot.
Step 3.
Install the memory module.
Figure 82. Memory module installation
a.
Make sure they are in the fully-open position. Align the keys on the memory module with the
connector.
b.
Firmly press both ends of the memory module straight down into the connector until the
retaining clips snap into the locked position.
After you finish
1. Reinstall the air baffle if it is removed. See
2. Install the top cover. See
3. Complete the parts replacement. See
PCIe adapter replacement
Use the following information to remove and install a PCIe adapter.
Remove a PCIe adapter (Riser)
Use this information to remove a PCIe adapter from the riser.
About this task
Attention:
• Replacing the adapter might impact your RAID configurations. Back up your data before the replacement
to avoid any data loss due to a RAID configuration change.
• Read the following section(s) to ensure that you work safely.
–
"Safety" on page iii
–
"Installation Guidelines" on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, remove the server from the rack.
ThinkSystem SR250 V2 Maintenance Manual
94
"Install the air baffle" on page
"Install the top cover" on page
"Complete the parts replacement" on page
11.
64.
134.
140.
Advertisement
Table of Contents
