Table of Contents
Advertisement
在直流输入状态下，若电源供应器插座不支持热插拔功能，请务必不要对设备电源线进行热插拔，此操作可能
导致设备损坏及数据丢失。因错误执行热插拔导致的设备故障或损坏，不属于保修范围。
NEVER CONNECT AND DISCONNECT THE POWER SUPPLY CABLE AND EQUIPMENT WHILE YOUR
EQUIPMENT IS POWERED ON WITH DC SUPPLY (hot-plugging). Otherwise you may damage the
equipment and result in data loss, the damages and losses result from incorrect operation of the equipment
will not be covered by the manufacturers' warranty.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Step 1.
If there is a power-supply-bay filler installed, remove it.
Step 2.
Note the orientation of the hot-swap power supply; then, slide it into the chassis until it snaps into
position.
Figure 38. Hot-swap power supply installation
Remove the front door
Use this information to remove the front door.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
.
Chapter 4
Server hardware setup
83
Advertisement
Table of Contents
