Cfm; Figure 4.55 L2 Switching > Loopback Detection > Port Settings; Figure 4.56 L2 Switching > Cfm > Cfm Settings - Advantech EKI-7428 Series User Manual

The ensuing table for Loopback Detection Global Information settings are
informational only: State, Interval and Recover Time.
4.5.13.2 Port Settings
The Port Settings page allows you to select ports that are detected by the loopback
detection function and configure their status (enabled or disabled).
To access this page, click L2 Switching > Loopback Detection > Port Settings.
Figure 4.55 L2 Switching > Loopback Detection > Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Enabled
Apply
The ensuing table for Loopback Detection Port Information settings are
informational only: Port, Enable State and Loop Status.
4.5.14

CFM

4.5.14.1 CFM Settings
To access this page, click L2 Switching > CFM > CFM Settings.
The following table describes the items in the previous figure.
Item
State
Apply
The ensuing table for Information settings are informational only: CFM State.
Description
Enter the port to define the local loopback detection setting.
Select Enabled or Disabled to setup the Loopback Detection
function.
Click Apply to save the values and update the screen.
Figure 4.56 L2 Switching > CFM > CFM Settings
Description
Click Enabled or Disabled to enable CFM settings.
Click Apply to save the values and update the screen.
67 EKI-7428 Series User Manual