Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM graphics expansion
Removing the PCIe graphics expansion from the compute module
Removing and replacing the drive backplane
This procedure can be used for removing and replacing the standard drive backplane or the premium drive backplane.
Prerequisites
To complete this procedure, you need a T-15 Torx screwdriver.
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6. Remove all drives and drive blanks.
7. Remove the front panel/drive cage assembly.
8. If you are removing the premium backplane, disconnect the premium drive backplane cable.
9. Remove the drive backplane from the front panel/drive cage assembly.
The cable shown in the image below is not required for a standard drive backplane.
Removal and replacement procedures
54
Advertisement
Table of Contents
