Removing And Replacing A Heatsink Blank - HPE Synergy 480 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame

Removing and replacing a heatsink blank

Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6. Remove the heatsink blank. Retain the heatsink blank for future use.
To replace the component, reverse the removal procedure.
Removal and replacement procedures
57