Table of Contents
Advertisement
Item
4
5
Drive numbering
Depending on the configuration, this graphics expansion module can support hard drives, SSDs, NVMe drives, and uFF drives
(supported in dual SFF flash adapters) in the drive bays. Depending on the device installed, the bay number might be different.
Item
1
2
Description
Mezzanine NIC status LED
Power On/Standby button
and system power LED
Hard drive/SSD bay
numbering
1
2
Status
Solid green= Link on any Mezzanine NIC
Flashing green= Activity on any Mezzanine NIC
Off = No link or activity on any Mezzanine NIC
Solid green = System on
Flashing green (1 Hz/cycle per sec) = Performing power on sequence
Solid amber = System in standby
Off = No power present
NOTE: If all other LEDs are off, no compute module power is present
(facility power is not present, power cord is not attached, power
supplies are not installed, power supply failure has occurred, or the
power button cable is disconnected). If the health LED is flashing green
while the system power LED is off, the Power On/Standby button
service is initializing or an iLO reboot is in progress.
uFF drive bay numbering
1 and 101
2 and 102
NVMe drive bay numbering
1
2
Component identification
97
Advertisement
Table of Contents
