Removing and replacing an SFF flash adapter
CAUTION: Removing the SFF Flash Adapter also removes two uFF drives and might cause one or more logical drives to
fail.
Procedure
1. Power down the graphics expansion module.
2. Slide the adapter ejection handle release latch up.
The handle will eject from the adapter.
3. Pull the adapter handle to remove the SFF flash adapter.
To replace the component, reverse the removal procedure.
Removing and replacing the front panel/drive cage assembly
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6. Remove all drives.
7. Remove the front panel/drive cage assembly.
Removal and replacement procedures
53