Enclosure Release Latch Assembly - HPE D2220sb Maintenance And Service Manual

Remove the drive drawer.
8.
To replace the component, reverse the removal procedure.
CAUTION: Be sure the pass-through board is fully installed before installing the drive drawer.
Otherwise, damage may occur to the pass-through board or drive drawer.

Enclosure release latch assembly

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: Do not operate the D2220sb with the access panel open or removed. Operating
the D2220sb in this manner results in improper airflow and improper cooling that can lead to
thermal damage.
To remove the component:
Back up all data on the D2220sb.
1.
Power down the partner server blade (on page 20).
2.
Remove the D2220sb (on page 20).
3.
Remove all drives ("Remove the drives" on page 22).
4.
Remove the access panel (on page 25).
5.
Remove the drive drawer ("Drive drawer" on page 36).
6.
Remove the bottom drive drawer slide assembly from the chassis.
7.
Removal and replacement procedures 38