To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM option card
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module from the frame.
3. Place the graphics expansion module on a flat, level surface.
4. Remove the access panel.
5. Remove the two screws on each side of the option card, flip up the option card, and pull it out.
NOTE: For option card slot details, see Multi-MXM graphics expansion module option card slots.
To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing PCIe card cages
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module from the frame.
Removal and replacement procedures
89