Removing And Replacing Dimm Baffles - HPE Synergy 480 Gen10 Maintenance And Service Manual

More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM graphics expansion
Removing the PCIe graphics expansion from the compute module

Removing and replacing DIMM baffles

Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6. Remove one or more DIMM baffles.
7. If the energy pack option is installed, remove it from the DIMM baffle.
To replace the component, reverse the removal procedure.
IMPORTANT: Be sure to install the energy pack option in the same baffle from which it was removed when replacing it.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM graphics expansion
Removing the PCIe graphics expansion from the compute module
Removal and replacement procedures
58