Correlating Pc / Mg 3200 Ip Address & Subnet Mask - Nortel Media Gateway 3200 User Manual

H.248 User's Manual
8.3.2.2 Disabling the Embedded Web Server
You can deny access to the device's Web Server by changing the default of ini file
parameter DisableWebTask. The ability to disable access to the device's Web Server via
HTTP provides a high level of security in which protection against unauthorized access
(such as Internet hacker attacks) is included. This is particularly important to users without
a firewall.
When the device is controlled through a PCI/cPCI bus, the Embedded Web Server is
always activated. The user cannot disable it in PCI mode.
To disable the Embedded Web Server:
Set the ini file parameter DisableWebTask to 1 (Default = 0, i.e. web task enabled).
Access to the device's Web Server is denied.
8.3.2.3 Encrypted HTTP transport (HTTPS - SSL)
Data transportation between Web server and Web client may be conducted over a secured
SSL link that encrypts the HTTP layer. The Web server may be configured to accept
communications only on a secured link (HTTPS) or both on a secured link (HTTPS) and a
non secured link (HTTP). For further details refer to the Appendix, ''Security'' on page 319.
8.3.2.4 Limiting Web Access to a Predefined List of Client IP Addresses
When client IP addresses are known in advance. Users can define a list of up to 10 client
IP addresses that are to be accepted by the Web server. Any client that does not bear an
IP address in the predefined list is unable to connect to the Web server. For further details
refer to the Appendix, ''Security'' on page 319.
8.3.2.5 Managing Web Server Access Using a RADIUS Server
Users are given the option to manage the web server's password-username pairs via a
RADIUS server. When this option is used the Dual level access scheme is disabled and all
users that access the web server are deemed to be Administrators with Read/Write
privileges. For further details refer to the Appendix, ''Security'' on page 319.
8.3.3 Correlating PC / MG 3200 IP Address & Subnet Mask
Before using the Web browser to access the MG 3200's Embedded Web Server, change
the PC's IP address and Subnet Mask to correspond with the MG 3200's factory default IP
address and Subnet Mask shown in the table below. For details on changing the IP
address and Subnet Mask, refer to the Help information provided by the Operating System
used.
Version SN09 143
8. MG 3200 Management
October 2006