Nortel Media Gateway 3200 User Manual page 412

This equipment complies with Part 68 of the FCC rules and the requirements adopted by
ACTA. On the interface card module of this equipment is a label that contains a product
identifier in the format US: AC1ISNANTP1610. If requested this number must be provided to
the telephone company.
The Telephone company may make changes in the facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service. Should you experience trouble with this telephone equipment,
contact: Nortel at www.nortel.com. Do not attempt to repair this equipment!
Facility Interface Code: 04DU9.BN, 04DU9.DN, 04DU9.1KN, 4DU9.ISN
Service Order Code: 6.0N
USOC Jack Type: RJ21X or RJ48C
It this gateway causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice isn't
practical, the telephone company will notify the customer as soon as possible. Also you will be
advised of your right to file complaint with the FCC if you believe it is necessary.
Network Information and Intent of Use
The products are for access to ISDN at 2048 kb/s and for access to G.703 Leased lines at
2048 kb/s.
The products support the Telecom networks in EU that comply with TBR4 and TBR13.
The safety status of each port is declared and detailed in the table below:
User's Manual
Digital Device Warnings
Network Compatibility
Telecommunication Safety
Ports
E1 or T1
Ethernet (100 Base-T)
412
Safety Status
TNV-1
SELV
MG 3200
Document # LTRT-72704