To Reboot The System; To Verify That The Srg50 Has Been Created Successfully; To Increase The Number Of Survivable Ip Users - Nortel SRG50 Configuration Manual

To reboot the system

1 Navigate to the Reset panel (Administration > Utilities > Reset).
2 Click the Reboot BCM50 System button.

To verify that the SRG50 has been created successfully

1
Apply the SRG50 application update and first keycode as instructed in the preceding
procedures.
2 Launch the BCM50 Element Manager.
3
Connect to the BCM50.
4 Navigate to the System Identification panel (Configuration > System > Identification).
5 Verify that the entry in the Description field is SRG (Telephony Only).
6
Navigate to the Keycodes panel (Configuration > System > Keycodes).
7 In the Feature licenses table, verify that the Status of the SRG keycode is ACTIVE.
8 Open the Resources folder (Configuration > Resources).
9
Verify that there is a Survivable Remote Gateway panel.
Warning: Reversability — A Level 1 or Level 2 reset causes the
SRG50 to revert to BCM50 functionality. Refer to the BCM50
Installation & Maintenance Guide (N0027152) for details.

To increase the number of survivable IP users

After the initial keycode has been applied and the system has been rebooted, the number of
survivable IP users can be increased to 16, 24, or 32 by the application of additional keycodes. To
apply these keycodes, follow the procedure provided above for applying the initial keycode.
Note: You can apply one, two, or three keycodes in one session but you
must reboot the system for the keycodes to take effect. Once additional
keycodes have been applied, the Data column of the Feature licenses
table (Configuration > System > Keycodes) updates to reflect the new
number of users.
Chapter 1 Getting started
Survivable Remote Gateway 50 Configuration Guide
13