Table of Contents
Advertisement
To send a Call Progress Tone, CAS, or Voice Prompt file to the
board, take these 6 steps:
1.
From the main menu list on the left, click on the Advanced Configuration link. The
Advanced Configuration screen appears.
2.
From the sub-menu bar on the top, click the Regional Settings link. The Regional
Settings screen appears. (Refer to the figure below.)
3.
Click the Browse button to locate the predefined Call Progress Tone, CAS, or Voice
Prompt file as appropriate. (A new software file package may be issued from Nortel or
your local supplier.)
4.
Click the Send File button. The file is sent to the board, overwriting the previous one.
The screen is refreshed and a message informs you about the waiting period. When
the loading is complete, a verification message is displayed at the bottom of the
screen: File XXX was successfully loaded into the device.
5.
For CPT file downloading only - (The rest of files do not require a device reset.) From
the main menu list on the left, click Reset. The Reset screen appears.
6.
Select the Burn option and click the Restart button. Wait for the device to reset. After
self-testing, the Ready and LAN LEDs on the device's front panel are lit green. Any
malfunction causes the Ready LED to change to red.
To set the date and time, take these 2 steps:
1.
Enter the date and/or time using the YYYY, MM, and DD field for Year, Month and
Day and HH, MM, and SS fields for Hour, Minutes and Seconds.
2.
Click the Set Date and Time button.
accordingly.
Note:
Settings screen), the date and time are in Read Only mode as they are set by the
NTP server.
User's Manual
When the NTP feature is enabled (the NTP server is defined in the Network
The date and time is set on the device,
180
MG 3200
Document # LTRT-72704
Advertisement
Table of Contents
Troubleshooting
