Nortel Media Gateway 3200 User Manual page 247

H.248 User's Manual
ini File Field Name
EnableDiagnostics
EnableDNSasOAM
EnableICMPUnreachableReport Reports receipt of unreachable ICMP
EnableIPAddrTranslation
EnableLANWatchdog
Version SN09
Table 12-3: Infrastructure Parameters
Description
2 = Enable (trigger by GARP)
3 = Enable (trigger by either media or
GARP)
Checks the correct functionality of
the different hardware components
on the board. On completion of the
check, the board sends an
EV_END_BIT value, which contains
information on the test results of
each hardware component.
0 = No diagnostics (default).
1 = Perform diagnostics (full test of
DSPs, PCM, Switch, LAN, PHY and
Flash).
2 = Perform diagnostics (full test of
DSPs, PCM, Switch, LAN, PHY, but
partial, test of Flash, a quicker
mode).
Sets the location of the DNS. If this
parameter is set and the machine is
functioning in multiple IPs mode, the
DNS is located on the OAM network.
If not, the DNS is on the control
network.
packets.
0 = Disabled; 1 = Enabled
Specifies the type of compare
operation performed on the first
packet that is received on a newly
opened channel for the Network
Address Translation (NAT) feature. If
set to 1, the board compares the first
incoming packet's source IP address,
to the remote IP address stated in
the opening of the channel. If the two
IP addresses do not match, the NAT
operation takes place. Consequently,
the remote IP address and the UDP
port of the outgoing stream are
replaced by the source IP address
and UDP port of the first incoming
packet.
0 = Disable; 1 = Enable
Detects LAN failures on the board. A
LAN failure can result from a
247
12. Appendix - Individual ini File Parameters
Host/Manual
Default Value
Valid
Range
0 0 to 2
1 0 or 1
1 0 or 1
1 0 or 1
0 0 or 1
October 2006