Tadiran Telecom Aeonix T200M Series Installation Manual page 30

22 Phone Hardware Description
Installing the Handset
The handset cord comes with the same connector type on both ends.
1
Take one end of the cord and place it into the socket located at the bottom of
the handset. The connector fits properly in one direction only. If the connector
does not fit into the socket easily, turn it over and retry.
2
Take the free end of the handset cord and place it into the socket located on
the left side of the telephone body. (The socket is marked with a handset
symbol. See Figure
connector does not fit into the socket easily, turn it over and retry.
Do not place the handset connector into the sockets located underneath the
telephone body. These sockets are for connecting the telephone to the LAN
and the PC.
Installing the Headset
The phone can be fitted with an optional headset (provided by the customer). The
headset must be equipped with a 4 pin RJ-9 connector.
When the headset is connected through socket #2, the headset is active and
the handset (connected in socket #1) is inactive. See
To install the headset, take the free end of the headset cord and place it into the socket
located on the left side of the telephone body. (The socket is marked with a headset
symbol. See Figure 8.) The connector fits properly in one direction only. If the
connector does not fit into the socket easily, turn it over and retry.
8.) The connector fits properly in one direction only. If the
Figure 8.
T200M Series Installation Manual - Aeonix