Connecting A 56G Ib Cable - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Step 6 Check that the new cable is properly connected.
Power on the device, and ping the IP address of the peer device connected over
the new cable. If the peer device cannot be pinged, check that the cable is intact
or the connector is securely connected.
Step 7 Bind the new optical cable.
Bind the new optical cable in the same way as existing optical cables. You can also
remove all cable ties and bind all of the optical cables again if necessary.
----End

3.5.4 Connecting a 56G IB Cable

If a 56G IB cable is to be replaced, ensure that the new cable is of the same model
as the one to be replaced or is compatible with the server.
The following tools are available:
●
●
Procedure
Step 1 Check the model of the new network.
Step 2 Number the new cable.
●
●
Issue 46 (2022-12-28)
Figure 3-19 Connecting an SFP+ cable
Phillips screwdriver: used to tighten screws
ESD wrist strap or ESD gloves: used to prevent ESD damage
The new cable must have the same number as the old one.
Use the same type of labels for optical cables. Record the name and number
of the local device to be connected on one side of an optical cable and those
of the peer device on the other side. Attach a label 2 cm (0.79 in.) away from
the end of a network cable.
Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the RH2288H V3
100