Indicators And Buttons - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Port
USB port
Table 2-4 Ports on the rear panel
Port
VGA port
USB port
Managemen
t network
port (Mgmt)
Serial port
Network
port

2.4 Indicators and Buttons

Front Panel
You can observe the indicators to determine the status of the RH2288H V3.
Table 2-5
Issue 46 (2022-12-28)
Type Quanti
ty
USB 2.0 2
Type Quant
ity
DB15 1
USB 3.0 2
Ethernet 1
port
DB9 1
- -
describes the indicators and buttons on the RH2288H V3 front panel.
Copyright © Huawei Technologies Co., Ltd.
Description
The USB ports are connected to USB
devices.
NOTE
Before connecting to an external USB device,
check that the USB device operates properly. A
server may fail if it is connected to an abnormal
USB device.
Description
The VGA port is used to connect a terminal,
such as a monitor or KVM.
The USB ports are connected to USB
devices.
NOTE
Before connecting to an external USB device,
check that the USB device operates properly. A
server may fail if it is connected to an abnormal
USB device.
USB 3.0 is disabled by default. You can enable it
on the BIOS as required.
The 1000 Mbit/s Ethernet port is used to
manage the server.
Three-pin serial port. The default baud rate
is 115200 bit/s.
The serial port is used as the system serial
port by default. You can set it as the iBMC
serial port by using the iBMC command.
The port is used for debugging.
The port types and quantity vary according
to the FlexIO card configured.
2 Overview
20