Connecting A Power Cable - Huawei RH2288H V3 User Manual

RH2288H V3 Server
User Guide
Figure 3-23 Connecting a serial cable
Do not use excessive force; otherwise, the pins in the serial port may be damaged.
Step 2 Tighten the screws on the connector to secure the serial cable.
----End

3.5.7 Connecting a Power Cable

The following describes how to connect AC and DC power cables. Connect AC or
DC power cables based on the PSU type.
Before connecting power cables, ensure that the server and its internal
components have been installed, and the PGND cable is connected to the server
(for the RH2288H V3, which does not provide ground terminals, connect the
PGND cable to the cabinet where the server is located). Use dedicated power
cables to ensure equipment and personal safety. Power cables must be securely
connected. Power cables are used only for dedicated servers. Do not use them for
other devices.
The following tools are available:
ESD wrist strap or ESD gloves: used to prevent ESD damage
Connecting an AC Power Cable
Step 1 Wear an ESD wrist strap.
Step 2 Connect one end of the AC power cable to the power port on the PSU of the
server.
●
Issue 46 (2022-12-28)
NO TICE
If the PSU has a velcro strap, use the velcro strap to bind the power cable to
the middle of the PSU handle after connecting the power cable to the PSU to
prevent power cable poor contact or disconnection. See
Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the RH2288H V3
Figure 3-24.
104