Install The Eio-04 Under-Seat Slope Bracket With The Access Point Against A Stadium Riser Slope Using Eio-Gasket - Extreme Networks AP560i Installation Manual

Install the Access Point
Install the EIO-04 Under-Seat Slope Bracket with the Access Point Against a
Stadium Riser Slope Using EIO-GASKET
Learn how to install the EIO-04 under-seat enclosure with the AP560i access point on a flat surface,
with EIO-GASKET sealing the space between the slope bracket and the stadium riser.
Before You Begin
Table 8: Hardware requirements for flat surface installation
Item quantity
1
4
4
2
1
1
4
About This Task
The EIO-GASKET keeps the debris from getting between the ramp base and a wall or a stadium riser.
The EIO-GASKET supports the EIO-04 ramp bases.
The EIO-GASKET is made of compressible silicone rubber.
The best practice is to use the EIO-GAKET when the ramp base cannot be pressure washed from
behind or when debris can be pushed behind the ramp base by a pressure washer. For information on
pressure washing guidelines, see
Install the EIO-04 Under-Seat Slope Bracket with the
Access Point Against a Stadium Riser Slope Using EIO-
Description
AP560i access point
M6 screws with integral washers
75 mm service panel shoulder screws
Metal "L" bracket
Plastic service panel base
Plastic service panel top with one captive screw
Concrete anchors with nuts, washers, anchor posts, and anchor
sleeves
EIO-GASKET silicone rubber kit that ships with the under-seat
enclosure:
Table 8: Hardware requirements for flat surface
installation
Table 9: EIO-GASKET box contents (ordered
separately)
Part number
EIO-GASKET
Power or Pressure Washing Guidelines
ExtremeWireless™ AP560i Access Point
Box contents
Two silicone rubber gaskets
Two shoulder screws (security
torx, T20 bit-size)
One URL card
on page 47.
GASKET
25