Install The Access Point To A Wall With Ah-Acc-Bkt-Ax-Wl - Extreme Networks ExtremeWireless AP3000X Installation Manual

Install the Access Point to a Wall with AH-ACC-BKT-AX-
WL
Figure 11: AH-ACC-BKT-AX-IL accessory bracket circular tip
Call out
1
5. Press and rotate the access point clockwise about one-sixth of a turn until it locks
into place on the accessory bracket.
6. Connect the network cable.
7. Place the cable cover over the Ethernet cable.
8. Replace the ceiling tiles.

Install the Access Point to a Wall with AH-ACC-BKT-AX-WL

Before You Begin
You need the following items:
•
AP3000X
•
Three M3.5 screws and three screw-in anchors, shipped with the -WL bracket
•
One AH-ACC-BKT-AX-WL bracket
About This Task
Use the AH-ACC-BKT-AX-WL bracket when you need a 1.25 in. space between the wall
and the access point.
Procedure
1. Using the -WL bracket as a template, mark and drill mounting holes on the wall.
28 ExtremeWireless™ AP3000X Access Point Installation Guide
Description
AH-ACC-BKT-AX-IL bracket circular tip
Access Point Installation