Install The Eio-04 Under-Seat Slope Bracket And The Access Point - Extreme Networks AP5050U Installation Manual

Install the EIO-04 Under-Seat Slope Bracket and the
Access Point
•
Flat vertical surface such as stadium riser

Install the EIO-04 Under-Seat Slope Bracket and the Access Point

Install the EIO-04 under seat enclosure with the AP5050U access point on a stadium slope.
Before You Begin
Obtain the items shown in the following table.
Table 9: Hardware Requirements for Slope Installation
Item quantity
1
6
4
2
2
2
1
1
1
1
Attach the metal sloping bracket on a slope:
1. Using the metal sloping bracket as a template, mark and drill two holes in the concrete.
2. Insert the anchors without the nuts and washers.
3. Place the metal sloping bracket, attach the nuts and washers to the exposed threads, and torque
them to 60 in-lbs.
22 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Note
◦ If the service panel base extends above the stadium riser, caulk along the service panel,
the outdoor access point, and the riser top.
◦
Leave approximately 1-inch between the outdoor access point bottom and the floor.
The gap will ensure that any water that stays on the exterior surface of the access point
can drip out.
Description
AP5050U access point
10 mm M6 screws with integral washers
75 mm service panel shoulder screws
Anchor posts
Flat washers for anchors
Lock washers for anchors
Metal "L" bracket
Plastic service panel base
Plastic service panel top with captive screw
Metal sloping bracket
Install the Access Point