Extreme Networks AP560i Installation Manual page 24

Install the Access Point on a Flat Surface Using EIO-04
Brackets
Procedure
1. Attach an EIO-04 metal "L" bracket on each side of the AP560i access point using two M6 screws
for each bracket.
2. Torque the M6 screws to 35 in-lbs.
3. Use the metal "L" brackets as a template, mark four hole centers, and drill in the concrete.
4. Insert four concrete anchors into the holes without the washers and nuts.
5. Place the metal "L" bracket over the threaded anchor posts and put on the flat-washer, the spring
washer, and the nut on each side.
6. Torque the nuts to 60 in-lbs.
Figure 3: AP560i flat surface installation with metal "L" brackets
What to Do Next
Install the Plastic Service Panel on the Access Point
24 ExtremeWireless™ AP560i Access Point
Note
When installing the access point flat against a surface in a location that uses ice melt, the
best practice is to apply an anti-seize material to the screws before attaching them to the
access point metal base.
on page 44.
Install the Access Point