Extreme Networks AP560i Installation Manual page 22

Install the EIO-04 Under-Seat Slope Bracket and the
Access Point
Figure 2: Metal sloping bracket conduit holes
Callout
1
2
3. If you are using the left side conduit hole on the metal sloping bracket, attach the correct size
conduit cover to the conduit hole.
You can use an 1 in. NPT or a ¾ in. NPT conduit on the EIO-04 conduit holes.
4. Tighten the locking nut.
5. If you are using the conduit hole in the slope, attach the conduit coupler and the locking nut directly
to the slope conduit hole.
6. If you are using the right side conduit hole in the slope, repeat
7. Run the cable through the conduit and add the RJ45 connectors to the wires.
For more information about GE1 or GE2 cable, refer to
22 ExtremeWireless™ AP560i Access Point
Description
Conduit holes on either sides of the metal sloping bracket
Conduit cable holes in the slope
Note
If you are using a ¾ in. NPT, use the conduit cover that comes with the unit to cover the
conduit hole.
Note
The conduit must be 1 in. in diameter to attach the conduit coupler and the nut directly in
the slope.
Note
The cable should have 1 in. bend radius and be accessible to the glands on AP560i access
point.
Install the Access Point
step 3.
Connect the GE1 or GE2 cable topic.