Install The Eio-04 Under-Seat Slope Bracket And The Access Point - Extreme Networks AP560i Installation Manual

Install the Access Point

Install the EIO-04 Under-Seat Slope Bracket and the Access Point

Install the EIO-04 under seat enclosure with the AP560i access point on a stadium slope.
Before You Begin
Table 6: Hardware requirements for slope installation
Item quantity
1
6
4
2
2
2
1
1
1
1
Attach the metal sloping bracket on a surface:
1. Using the metal sloping bracket as a template, mark and drill two holes in the concrete.
2. Insert the anchors without the nuts and washers.
3. Place the metal sloping bracket, attach the nuts and washers to the exposed threads, and torque
them to 60 in-lbs.
About This Task
Attach the conduit cable through the conduit holes on the metal sloping bracket, then attach the metal
L bracket to the access point, and install the access point on a slope.
Procedure
1. Attach the conduit couplers to the conduit.
2. Remove the locking nut.
For the conduit hole that is not used, insert a blank conduit cover over the conduit hole in the slope.
Install the EIO-04 Under-Seat Slope Bracket and the
Description
AP560i access point
10 mm M6 screws with integral washers
75 mm service panel shoulder screws
Anchor posts
Flat washers for anchors
Lock washers for anchors
Metal "L" bracket
Plastic service panel base
Plastic service panel top with captive screw
Metal sloping bracket
ExtremeWireless™ AP560i Access Point
Access Point
21