New In This Document; Introduction Of Eio-Gasket; When To Use The Eio-Gasket In A Stadium Environment; Installation Do's And Don'ts - Extreme Networks AP560i Installation Manual

New in this Document

Learn about documentation updates.

Introduction of EIO-GASKET

The EIO-GASKET is a replacement for the EIO-02 silicone rubber kit. The EIO-GASKET is used to keep
debris from getting between the ramp base and the wall or a riser in a stadium environment.
The EIO-GASKET is used in combination with the EIO-04 under seat indoor or outdoor enclosure.

When to use the EIO-GASKET in a stadium environment?

•
When pressure washer pushes debris behind the ramp base
For EIO-GASKET purchase information, see
For EIO-GASKET installation information, see
Access Point Against a Stadium Riser Slope Using EIO-GASKET

Installation Do's and Don'ts

A set of guidelines to ensure proper installation and maintenance of access point for different
installation scenarios.
Note
The console port cap must be tightened to a torque of 12 in-lbs.
If a torque wrench is not available, a flat-bladed screwdriver can be used. The flat blade must
be 7/16 in. wide to avoid noticeable cap slot deformation.
For proper guidelines, see
AP560i Purchase Order Information
Install the EIO-04 Under-Seat Slope Bracket with the
Note
The slot deformation will not affect the IP67 console port cap properties.
Installation Do's and Don'ts
on page 12.
on page 25.
on page 19.
ExtremeWireless™ AP560i Access Point 9