Extreme Networks AP560i Installation Manual page 40

Install the Access Point on a Pole Using KT-147407-02
Bracket Parts and KT-150173-01 Extension Arm
4. Attach the KT-147407-02 pole part to the other end of the KT-150173-01 extension arm using two
M12 screws and M12 hex-nuts.
Figure 14: Attaching the KT-150173-01 extension arm to the 1-axis tilt part of the KT-147407-02
bracket
5. Insert 0.5 in. stainless-steel cable clamps through the KT-147407-02 pole part long slots.
6. Position the cable clamps around a pole and attach the pole bracket to a pole.
7. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Mount the Access Point to a Pole using the Pole Part of the KT-147407-02 Bracket
Before You Begin
The following hardware is required for pole installation using KT-147407-02 pole bracket part to the
access point:
•
Pole part of the KT-147407-02 bracket
•
Four M6 screws
40 ExtremeWireless™ AP560i Access Point
Install the Access Point