Extreme Networks AP560i Installation Manual page 18

Access Point Bracket Usage and Mounting Options
Table 5: AP560i mounting bracket usage (continued)
Mounting bracket
and part number
MBO-ART02
WS-MBO-POLE01
(#30520) bracket
Warning
When installing the access point on a wall or to a pole, the cable glands must face down.
Note
When using the MBO-ART02 articulating mounting bracket with the access point, set the
bracket downward tilt to less than 20 degrees to prevent water ingress.
Related Topics
AP560i Purchase Order Information
18 ExtremeWireless™ AP560i Access Point
Wall install Pole install
Yes Yes
No Yes (must be used
with the MBO-
ART02 bracket)
on page 12
Install the Access Point
Under-seat install Notes
No The articulating
mounting bracket
is paired with the
POLE01 bracket for
pole installations.
For wall
installations, the
wall must be
strong enough
to support the
access point during
inclement weather
No If the pole
diameter is <=
1.0 in. (25.4 mm),
use small cable
clamp. If the
pole diameter is
between 5.0 in.
- 7.0 in. (178.0
mm), use large
cable clamp. For
any other pole
diameter, provide
your own stainless
steel cable clamp.
The band must be
0.5 in. (12.7 mm)
wide
The POLE01
bracket can
be used only
when paired with
the MBO-ART02
bracket