Kt-147407-02 Bracket Order Information - Extreme Networks AP560i Installation Manual

AP560i Overview
The ordering details are described in the following table.
Part number
EIO-04
Table 4: EIO-GASKET box contents (ordered separately)
Part number
EIO-GASKET

KT-147407-02 bracket order information

You can install the access point to a wall using the KT-147407-02 bracket parts (+/-15 degree, 1-axis) or
the MBO-ART02 (20 degree increments +/-80 degrees, 10 inch extension).
You can install the access point to a pole using:
•
KT-147407-02 bracket parts (+/-15 degree, 1-axis), or
•
MBO-ART02 (20 degree increments +/-80 degree, 10 inch extension) with the WS-MBO-POLE01
(#30520) bracket
Note
You can attach the access point to a wall using the MBO-ART02 bracket. However, if you
are using the MBO-ART02 bracket to attach the access point to a pole, you must use the
WS-MBO-POLE01 bracket along with the MBO-ART02 bracket.
KT-147407-02 bracket order information
Box contents
• EIO-04 Quick Reference Guide
• Metal sloping bracket
• Metal "L" brackets
• Plastic service panel base
• Plastic service panel top with one captive screw
• Conduit covers:
Two blank conduit covers for the metal sloping bracket
◦
Two blank conduit covers for the service panel base
◦
One ½ in. conduit cover each for the metal sloping bracket
◦
and the service panel base
One ¾ in. conduit cover each for the metal sloping bracket
◦
and the service panel base
• A hardware bag containing the following parts:
Six 10 mm M6 screws with integral washer
◦
Four 75 mm service panel shoulder screws
◦
Four anchor posts
◦
Four anchor sleeves
◦
Four flat washers for anchors
◦
Four lock washers for anchors
◦
Anchor assembly instruction sheet
◦
Box contents
Two silicone rubber gaskets
Two shoulder screws (security torx, T20 bit-size)
One URL card
ExtremeWireless™ AP560i Access Point 13