Extreme Networks AP560i Installation Manual page 38

Install the Access Point on a Pole Using KT-147407-02
Bracket Parts
2. Attach the KT-147407-02 pole part to the 1-axis tilt bracket using two M12 bolts through the large
bracket holes on the 1-axis tilt bracket and the pole bracket.
3. Fasten the bolts using two M12 hex nuts.
Figure 13: AP560i access point with KT-147407-02 bracket parts
Callout
A
B
C
4. Insert 0.5 in. stainless-steel cable clamp through the long slots on the pole bracket.
5. Position the cable clamps on the pole bracket around a pole and attach the pole bracket.
6. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
38 ExtremeWireless™ AP560i Access Point
Description
Flat part of the KT-147407-02 bracket, with two holes on the metal
surface
1-axis tilt bracket, with large holes on the surface
Pole bracket
Install the Access Point