Ge1 Or Ge2 Cable Connection Through The Metal Sloping Bracket - Extreme Networks AP560i Installation Manual

GE1 or GE2 Cable Connection Through the Service Panel
Base
Procedure
1. Using the blank conduit cover, cover the front hole of the service panel base.
2. Attach either the ½ in. conduit cover or the ¾ in. conduit cover to the rear hole of the service panel
base.
3. Bring in the GE1 or GE2 cable, and the ground wire through the rear side hole of the service panel
base.
4. Loosely align the service panel base next to the metal sloping bracket, thereby leaving enough
space to attach the GE1 or GE2 cable to the access point.
5. Attach the ground wire to the access
6. Remove the gland caps, plastic cage, and the gasket from the GE1 port.
7. Connect the GE1 LAN cable through the GE1 gland port until it clicks into place in the GE1 port.
If there is a GE2 connection, insert the cable through the GE2 gland until it locks into place in to the
GE2 port.
8. Torque the gland cap to 12-in lbs.
9. Fold and arrange the GE1 cable into the gap of the metal sloping bracket and the service panel base.
The GE1 cable must not be bent sharply and must have 1 in. bend radius.

GE1 or GE2 Cable Connection Through the Metal Sloping Bracket

About This Task
Connect the GE1 or GE 2 cable through the large conduit hole on the metal sloping bracket.
Note
You must provide the appropriate conduit connector.
The following hardware is required to connect the GE1 or GE2 cable using the large conduit hole on the
metal sloping bracket:
•
GE1 or GE2 cable
•
Two blank conduit covers to cover the front and the rear holes on the side of the service panel base
•
One metal sloping bracket
Note
The conduit cover used on the metal sloping bracket can extend above the concrete floor but,
cannot extend above the slope.
Note
Put the removed parts onto the LAN cable to be attached to the access point later.
GE1 or GE2 Cable Connection Through the Metal
point.
ExtremeWireless™ AP560i Access Point
Sloping Bracket
51