Extreme Networks AP560i Installation Manual page 41

Install the Access Point
•
Two 0.5 in. wide stainless-steel cable clamps
•
One access point
About This Task
The pole part of the KT-147407-02 bracket is attached to the access point for pole installation. To mount
the access point to a pole using the KT-147407-02 pole bracket part:
Procedure
1. Attach the pole part of the KT-147407-02 bracket to the access point using four M6 screws.
Align the four hinges of the pole part of the KT-147407-02 bracket against the holes on the access
point to attach the M6 screws.
2. Attach the pole bracket to a pole by following steps 5, 6, and 7.
Mount the Access Point to a Pole using the Pole Part of the KT-147407-02 Bracket and the
KT-150173-01 Extension Arm
Before You Begin
The following hardware is required for pole installation using KT-147407-02 pole bracket part and the
KT-150173-01 extension arm:
•
Pole part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
Four M6 screws
•
Two hex-head M12 stainless-steel screws
•
Two hex-head M12 stainless-steel nuts
•
Two 0.5 in. wide stainless-steel cable clamps
•
One access point
About This Task
The extension arm is used with the pole part of the KT-147407-02 bracket on the access point for pole
installation. To mount the access point to a pole using the KT-147407-02 pole bracket part and the
KT-150173-01 extension arm:
Procedure
1. Attach the KT-150173-01 extension arm to the access point using two M6 screws.
2. Attach the pole bracket part of the KT-147407-02 bracket to the other end of the KT-150173-01
bracket using two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts.
3. Attach the pole bracket to a pole by following steps 5, 6, and 7.
Install the Access Point on a Pole Using KT-147407-02
Bracket Parts and KT-150173-01 Extension Arm
ExtremeWireless™ AP560i Access Point 41