System Settings (System Config Menu) - Sony DVS-9000 User Manual

1
2
Note
Be sure to carry out this operation after reconfiguring the system, or after a
software upgrade.

System Settings (System Config Menu)

To make the system settings, use the System>System Config menu.
To display the System Config menu
In the Engineering Setup menu, select VF1 'System' and HF2 'System
Config.'
Note
After changing any of the following settings, be sure to press [Execute] to save
the new values. If you want to cancel the setting changes without saving them,
press [Clear].
Selecting the system operation mode
In the <System Operation Mode> group of the System>System Config menu,
select one of the following.
Single Proc: Control mode in which the panel controls a switcher and up to
Dual Simul: Control mode in which the panel controls two switchers and the
Specifying the switcher controlled by the control panel
Use the following procedure.
1
76
Setup for the Whole System
In the System>Network Config menu, press [Auto Config].
Turn the MKS-8010 System Control Unit off, then on again to restart the
unit.
This automatically checks all devices (excluding the DCU) connected to
the Data LAN, and shows the results in the status area of the
System>Network Config menu.
two DMEs connected to the switcher.
DME connected to each switcher simultaneously.
In the System>System Config menu, press the [Panel Assign] button.
The Panel Assign menu appears.