Chapter 2 - Using The Bluevision Interface - Spectra Stack Tape Library User Manual

CHAPTER 2 - USING THE BLUEVISION INTERFACE

C
HAPTER
I
NTERFACE
This chapter provides information on using the BlueVision interface.
Using the Operator Control Panel
Using the Remote Management Interface
Library User Types
Logging into the Library
Using the Library Main Screen
Top Banner Elements
Left Pane Elements
Right Pane Elements
Center Pane Elements
The library provides two main interfaces:
• Operator Control Panel (OCP) - With the OCP, you can monitor, configure, and
control the library from the LCD screen on the controller module.
• Remote Management Interface (RMI) - With the RMI, you can monitor, configure,
and control the library from a web browser. The RMI hosts a dedicated, protected
website that displays a graphical representation of the library.
The OCP and RMI are similar in design and functionality.
Before using the RMI, you must configure the library network settings and set the
administrator password with the OCP. This is typically done using the Initial
Configuration Wizard, see
When possible, it is recommended that the RMI be used as the primary library
interface because the web interface provides access to additional features, such as
configuring SNMP, IPv6, encryption, and partitions, includes online help, and is
easier to use.
JANUARY 2023
2 - U
SING THE
Using the Initial Configuration Wizard on
B
LUE
47
V
ISION
page 60.
SPECTRA STACK LIBRARY
USER GUIDE
48
49
50
51
52
53
54
56
56