Desktop Mounting The Tlp 1000Tv; Freestanding; Swivel Mount Adapter - Extron electronics TLP 1000MV User Manual

Desktop Mounting the TLP 1000TV

Freestanding

The TLP 1000TV is shipped with an attached stand that allows it to be placed on a desktop.
There are two mounting holes in the bottom surface of the stand. If required, these can be used
to secure the unit to the desktop.
Figure 43.
1.
2.
3.

Swivel Mount Adapter

The TLP 1000TV can be mounted with the Extron SMA-1 swivel mount adapter. This
allows the unit to be mounted permanently yet swivel up to 180° in either the clockwise or
counter-clockwise direction.
1.
2.
3.
TLP 1000TV Base, Showing Mounting Holes
Decide where the touchpanel will be installed.
Drill two holes through the desktop from underneath. The two holes must be 3.07 inches
(78 mm) apart.
Fasten the base to the desktop with two #8 wood screws (not provided). The screws pass
through the desktop from underneath and into the two holes in the base of the touchpanel.
Remove the back cover and base cover, using the Extron removal tool (see
TLP 1000TV Base for VESA Mounting
Set the TLP 1000TV on its back on a flat surface and remove the screw holding the locking
plate at the bottom of the base. This releases the weight, which can be removed, leaving the
mounting hole that will fit over the conduit of the SMA-1.
Locking Plate
Figure 44.
TLP 1000TV Base, Showing Locking Plate and Screw
Follow the instructions in the SMA-1 Swivel Mount Adapter Kit User Guide (available at
www.extron.com) to:
a.
attach the conduit, insulation disk, and swivel disk and configure the set screws.
b.
position the mounting hole in the base of the touchpanel over the conduit of the SMA-1.
c.
secure the touchpanel to the SMA-1 with the backing plate and locking nut.
Mounting Holes (2)
on the following page).
Locking Screw
TLP 1000MV and TLP 1000TV • Mounting
Removing the
41