Vesa Mounting The Tlp 1000Tv - Extron electronics TLP 1000MV User Manual

3.
4.
5.
6.
7.

VESA Mounting the TLP 1000TV

Before attaching the VESA mounting kit, remove the base and back of the TLP 1000TV, as
described in the previous section.
Once the base and back have been removed, the TLP 1000TV can be VESA mounted using the
Extron LPVM-1.
To VESA mount the TLP 1000TV with the LPVM-1, follow the instructions provided with the
mounting kit.
Figure 47.
If necessary, cut the zip tie holding the twisted pair cables to the TLP 1000TV base.
If necessary, remove the cables from the cable runway in the base.
Remove the four screws holding the hinges to the touchpanel.
NOTE:
The spanner drive screws holding the hinges require a #6 spanner bit or #6
spanner head screwdriver, which are not provided.
Connect the cables and, if necessary, fasten them to the back of the touchpanel with zip ties
(see figure 11 on page 14).
Attach the small back cover (provided). Fit the bottom catches into the slots on the bottom
of the panel and snap the side catches into place.
NOTE:
Run all cables through the hole at the bottom of the back cover (see figure 47
below).
VESA Mounting the TLP 1000TV with the LPVM-1
LPVM-1 Plate 2
Security Screws (4)
Small Back Cover
Hole for running cables
TLP 1000MV and TLP 1000TV • Mounting 43