Wall Mounting The Tlp 1000Mv With A Wall Box - Extron electronics TLP 1000MV User Manual

9.
Using a Phillips head screwdriver, tighten the screws for the locking arms. As the screws
tighten, the locking arms rotate behind the wall and hold the unit in place. Do not overtighten
the screws as this can damage the locking arms or the wall.
Faceplate snaps to unit
(4 places on each side).
Figure 41.
10. If required, perform the initial calibration using the
11. Replace the bezel by pressing the catches on the faceplate into the corresponding holes on
the front of the panel (four places on each side).

Wall Mounting the TLP 1000MV with a Wall Box

CAUTION:
partition assembly.
ATTENTION : Risque d'incendie — Ne pas installer le TLP 1000MV dans un mur
résistant au feu ou une cloison.
The TLP 1000MV can be wall mounted using the optional Extron BB 1000 or EWB 1000
mounting kits. Follow the instructions provided with the kit.
Locking Arms
(3 on top edge,
2 on bottom edge)
Tighten screws to
rotate locking arms.
Securing the TLP 1000MV to a Wall with Locking Arms
Fire Hazard — Do not install the TLP 1000MV in a fire resistant rated wall or
on-screen menus
TLP 1000MV and TLP 1000TV • Mounting
(see page 16).
39