Roland VersaUV LEF2-200 Service Notes page 219

Print Head Height Adjustment
11.
Select [SERVICE MENU] > [MOTOR MENU] > [AXIS MOVE] > [HEIGHT] to set the height to 103 mm and move the table to the
position which the print-head carriage is placed inside of the print area by pressing the
C AUT ION
Be sure that the table unit is in a position anterior to the head gap sensor plate .
When the table unit hits the plate, the table unit cannot rise to 103 mm .
12.
Loosen the screws fixing the print-head carriage again and push the print-head carriage downward so that the print head
is placed on the table .
Left frame
Right frame
Base carriage
2-78
[] Key .
[]
L EF 2-200
2